Rod ends DIN ISO 12240-4 (DIN 648) K series high performance version stainless steel with sealing female thread
Rod end K series high performance version stainless steel with sealing female thread
Static basic load rating C0 (kN)
The static basic load rating C0 (see additional columns) denotes the value with which a rod end can in normal applications with a static load be stressed in the weakest cross-section without being permanently deformed. It represents the permissible radial bearing strain at rest. The basic load ratings quoted have been calculated using the respective material characteristic values and can be verified by tensile experiments at room temperature. The yield point was used to 80%, making the safety factor until yield start 1.25.
The static basic load rating also enables the permissible thrust load to be calculated:
Fa = Fa perm. = p • C0 (kN)
p = < / ~ 0.2 for rod ends K series high performance version stainless steel with sealing
Dynamic basic load ratings for rod ends are available on request.
high performance version stainless steel with sealing
Filter - 7 out of 7 products selected
Additional columns
| Ordernumber | Size / Identifier | Material group | Surface | Thread version | Lubrication | Article no. | d | d Tolerance | A | B | B Tolerance | d1 | d2 | d3 | d4 | d5 | d7 | d8 | d9 | h1 | l3 | l4 | sw | Static basic load rating C0 (kN) | Permissible rpm* | Angle of misalignment α° | Bearing radial tolerance in mm min. - max. | Mass (g) per piece | CETOP | Shop |
|---|
Alternatively, there are also neoprene protective rubber caps for rod ends of size 6 to 35.
Details of the selected product
- Article no. 10 55 6483 1008/000
- Size / Identifier 8
- Material group Stainless steel A2 quality
- Surface bright
- Lubrication via cupped-type lubricating nipple DIN 3405; regular lubrication required using non-soap high-temperature grease with a high drop point to ensure consistent lubrication at high operating temperatures; working range: -50 °C to +250 °C; initial lubrication must be performed during initial operation
- Data sheet
-
Material
housing: stainless steel 1.4057 (X17CrNi16-2), forged, polished
size 40 stainless steel 1.4057, lathe work
bearing shell: special bronze CuSn8, alternative: stainless steel 1.4301 (X5CrNi18-10), 1.4542 (17-4Ph) etc.
internal ring: ball bearing steel 1.3505 (100Cr6), hardened, grinded, polished, hard chrome-plated on the bearing surface, alternative: stainless steel 1.4034 (X46Cr13), hardened, grinded, polished
sealing: NBR elastomer, temperature resistance -30 °C to +120 °C, resistant against mineral oils, greases and gasoline
fitting rings: brass
distance liner: stainless steel 1.4305 (X8CrNiS18-9)
This might also interest you
You are in the mbo shop. Please choose the article you require and activate an inquiry/order.
More about the shop