Go to homepage

Sleeves according to drawing

Product information "Sleeves according to drawing"

Sleeves are used to create or bridge a distance between two parts. In its basic form, a sleeve is a tube-shaped component. Sleeves are also often referred to as spacers, spacing rings, spacer tubes, bushes or distance rings. This simple part is required in practically every sector of industry because it can be customised and is economical to manufacture. One major advantage is the considerable reduction in installation time.

Range of services for custom sleeves (extract)

Machining range
  • Round Ø 4 mm up to Ø 65 mm
  • Length von 5 mm up to 350 mm
  • Small, medium and large batches
Machining capabilities/options
  • Cross holes
  • Grooves
  • Milled sections
  • Thread types:
    • metric or inch thread
    • regular, fine-pitch and left hand thread
  • Complicated geometries
  • Custom marking
  • Undercut steel
  • Stainless steel A2 quality
  • Stainless steel A4 quality
  • Other steels that are particularly corrosion-resistant, salt water-resistant or heat-resistant, as well as high-tensile steels
  • Coating
    • electroplated galvanised
    • Special surface
  • Treatment
    • free of grease
    • defined oil film
  • Finishing
    • Grinding
    • Tempering
    • Nitrocarburizing
Click here to go the configurator